Home Engineering Publications
DACS: A/D Converter Connection
  next up previous contents
Next: Control Board A/D Map Up: Digital Control Bus Previous: Mixer Unit I/O Map   Contents

A/D Converter Connection

Several of the modules in both the control board and the mixer unit require connection to the A/D converter present on the microcontroller modules. A generalized scheme for connecting devices to these A/D inputs is specified, such that a single ribbon cable with several inexpensive IDC connectors can be connected between all devices requiring A/D access. Each of these modules shall be equipped with a 10-pin 0.100 inch DIP header, with pinouts as shown in figure 39. A map of A/D port use is given for each piece of hardware in a later section.

Figure 39: Analog-to-digital converter connector pinouts.
\hspace{0.1in} \psfig{file=fig/header-10.eps}
...& reserved \\
10 & reserved \\

Steve Richardson 2000-07-06
Table of Contents

[PDF] [Whole document in PDF 1.9MB]

[more photos and information]

Page last modified:
Copyright © 1993-2000 prefect - All Rights Reserved.