Home Engineering Publications
DACS: Mixer Unit
  next up previous contents
Next: High-Level Firmware Design Up: Hardware Chassis Previous: Control Board   Contents

Mixer Unit

The mixer unit is built around an off-the-shelf 3 rack-unit chassis. The rear panel of this chassis was removed and replaced with an aluminum frame to hold the removable audio input and output cards. A rectangular hole was cut in the front panel to mount the LCD. The display is protected by a piece of acrylic. Internal components firmly mount to the chassis. Figure 93 shows the layout of the mixer unit components.

Figure 93: Mixer unit chassis layout, top view.
[model 411

Steve Richardson 2000-07-06
Table of Contents

[PDF] [Whole document in PDF 1.9MB]

[more photos and information]

Page last modified:
Copyright © 1993-2000 prefect - All Rights Reserved.